Mag Roller Coating

Our mag roller coating was developed for those remanufacturers that have employed a sandblaster to strip and resurface their own mag rollers. Our coating will cover the surface of a resurfaced mag roller to prevent that roller from oxidizing. The coating allows for a consistent, even charge from your mag roller for optimal print quality throoughout the print cycle. 2 oz. Bottle $32.00 (50+ Mags @ $.64 ea.), 16 oz. Bottle $199.00 (400 Mags @ $.50 ea.), 1 Gallon $1,100.00 (3,200 Mags @ $.34 ea.)

Application Instructions

1. Texture/refinish the mag roller.
2. Pour coating in a glass container. Place container on a hot plate (warmer). Coatings temperature should be between 75 and 110 degrees fahrenheit or 24 to 43 degrees celsius.
3. Place mag roller on the lathe. Turn lathe on at full speed and clean roller with alcohol. Wipe off any residue that the dried alcohol has left on the mag roller.
4. Immerse a clean foam swab into the warm Mag Roller Coating. Squeeze swab on the inside wall of the bottle to get the air out and allow swab to absorb the coating material.
5. Set lathes speed control between 50 and 60 on the dial.
6. Apply coating on the mag roller with the swab from left to right or right to left, moving your hand as quickly as possible (10 to 15 seconds). Make sure that all the textured part of the mag roller is coated. If the coating does not adhere to any part of the mag roller, there may be some residue on the roller, continue to apply the Mag Roller Coating on that spot until it adheres. Re-coat the roller and to even the coating.
7. Watch the coating dry and start increasing the lathes speed until you are running at full speed. You will be able to see the coating dry in about 30 seconds.
8. Apply cold water on a soft clean cloth. While the lathe is running at full speed, wipe roller with the wet cloth by just barely touching the roller. The gold pigment of the coating will come off on the cloth. This, however, is NOT an indication that the coating itself is coming off. Let roller dry (10 seconds). The cold water will set the coating.

    

   You can now use the mag roller immediately. The coating can only be applied on a mag roller that has been textured by the Ameri-Tech Concepts Inc. Cyclone Mag Roller Refinisher or by sand blasting equipment. The texture must be even for the coating to properly adhere to the roller.

   ---

   Click here to learn about the other supplies offered by Ameri-Tech Concepts, Inc.